Bently Nevada 330103-00-03-10-02-00 3300 XL 8mm Proximity Probe

Product Overview

The Bently Nevada 330103-00-03-10-02-00 acts as a critical sensing component within the 3300 XL 8mm Proximity Transducer System. This American-made eddy current probe provides precise, non-contact measurements of vibration and position in high-speed rotating machinery. We guarantee this unit as 100% Brand New and Original, ensuring full compliance with OEM performance standards for critical asset protection.

Part Number Breakdown

The 330103 series utilizes a specific configuration logic to meet diverse industrial mounting requirements. This specific unit features the following parameters:

Technical Specifications

This probe integrates seamlessly with 3300 XL Proximitor sensors to deliver linear output signals.

• Manufacturer: Bently Nevada (Made in U.S.A)

• Sensor Type: 8mm Non-contacting Eddy Current Probe

• Connector Type: Gold-plated ClickLoc™ Miniature Coaxial

• Total Length: 1.0 Meter

• Case Length: 3.0 Inches (Fully threaded)

• Shipping Weight: 1.5 Kg

• Condition: 100% Brand New, Factory Sealed

Engineering Advantages

• Enhanced Connector Integrity: The ClickLoc™ connector prevents accidental loosening due to machine vibration. The internal locking mechanism ensures a constant electrical connection without the need for specialized torque tools.

• Chemical Resistance: The probe cable features a high-performance PPS (Polyphenylene Sulfide) overmold, which resists degradation from moisture, oil, and corrosive industrial fluids.

• Interchangeability: As part of the 3300 XL family, this probe allows for complete interchangeability. You can replace individual probes, extension cables, or Proximitors without the need for recalibrating the entire system.

• Thermal Stability: The advanced design minimizes "thermal drift," maintaining measurement accuracy even as ambient temperatures fluctuate within the turbine housing or motor casing.

FAQs

How does the ClickLoc™ connector improve reliability compared to standard connectors?

The ClickLoc™ design features a physical detent that "clicks" when fully seated. This prevents the connector from backing out under high-frequency vibration, a common cause of signal loss in standard coaxial setups.

Can I use this 1.0m probe with a 5.0m or 9.0m Proximitor sensor?

You must match the total system length (Probe + Extension Cable) to the Proximitor's calibration. This 1.0m probe typically pairs with a 4.0m or 8.0m extension cable to achieve a total system length of 5.0m or 9.0m respectively. Check your Proximitor label to verify the required total system length.

What is the recommended installation torque for this 8mm probe?

To avoid damaging the probe tip or the mounting threads, technicians should apply a maximum of 11.2 N·m (100 in·lb) of torque during installation. We recommend using a thread-locking compound if the probe is subject to extreme vibration.