1783-SFP100FX | Allen Bradley | Fiber Optic SFP Transceiver

The Allen Bradley 1783-SFP100FX, also cataloged as the 1783-SFP100FX SFP Fiber Transceiver, operates as a dedicated hardware component for high-speed signal conversion between electrical backplane interfaces and optical media within Stratix Managed Switch platforms.

Hardware Specifications

Profinet / EtherNet/IP Deterministic Networks

The 1783-SFP100FX module integrates into the Stratix managed switch architecture to facilitate deterministic fiber optic data transmission. The transceiver supports backplane bus communication velocity requirements for Fast Ethernet, ensuring low-latency packet delivery across extended distances. System performance relies on firmware flash compatibility with the specific Stratix switch chassis to ensure proper initialization of the SFP port. I/O density scaling via fiber uplinks is dictated by the port availability on the switch, and the module provides Digital Optical Monitoring (DOM) to report real-time signal strength and operational status to the network management interface.

Frequently Asked Questions

Q: Does the 1783-SFP100FX support hot-swapping while the switch is operational?

A: Yes, this transceiver supports hot-swapping within a Stratix managed switch. Ensure the SFP slot is active and compatible before insertion. Note that some switches may require a configuration update to acknowledge the new transceiver.

Q: What are the primary cable specifications for this module?

A: This transceiver is designed for 62.5/125 micron multimode fiber optic cable. Using different core or cladding sizes may result in excessive signal attenuation and link failure. Ensure the dual LC connectors are clean and free of contamination before engagement.

Field Installation Guidelines

1. Inspection: Inspect the fiber optic cable ends and the SFP transceiver interface for dust or debris. Use approved fiber cleaning tools if necessary.
2. Insertion: Orient the transceiver with the correct polarity and slide it into the SFP cage of the Stratix switch until the locking mechanism clicks.
3. Cable Connection: Remove the protective dust cover from the Dual LC interface. Insert the fiber optic cable connectors until a mechanical click is heard.
4. Link Verification: Power on the switch and check the associated port status LEDs. A solid link light indicates a successful physical layer connection.
5. DOM Validation: Access the switch management interface to verify the DOM parameters. Ensure the received optical power levels are within the specified operational range to guarantee long-term data link stability.