Bently Nevada 330910-03-20-05-11-00 3300 NSv Proximity Probe

Configured for high-frequency vibration and position sensing in space-constrained applications, the Bently Nevada 330910-03-20-05-11-00 (3300 NSv Proximity Probe) provides direct physical signal acquisition for small-diameter rotating machinery.

Suffix Breakdown & Model Matrix

Hardware Specifications

Mechanical Monitoring and TSI Integration

The 3300 NSv system is engineered for applications where standard 8 mm probes are physically prohibited by mounting geometry. Accurate performance requires precise eddy-current probe scaling to ensure linear response within the specific target range. During installation, verify that gap voltage targets are centered at -10 VDC to ensure the transducer operates within its linear measurement region. Cross-talk suppression is maintained through high-frequency carrier signal isolation, preventing interference from adjacent probes in dense monitoring arrays, which is a common requirement for monitoring rotor dynamics on small, high-speed shafts.

Frequently Asked Questions

Q: Is this probe compatible with standard 3300 XL 8 mm Proximitor sensors?

A: No. The 3300 NSv system requires a dedicated 3300 NSv Proximitor sensor specifically calibrated for the smaller probe tip and higher resonance frequency of the NSv series.

Q: What are the benefits of the FluidLoc connector (suffix 11) in this assembly?

A: The FluidLoc connector provides an improved environmental seal, preventing liquid ingress into the coaxial cable dielectric, which is particularly relevant in machinery environments involving hydraulic or lubricating oils.

Field Installation Guidelines

1. Thread Engagement: Ensure the M10 x 1 threads are free of debris. Use a calibrated torque wrench to apply the recommended installation torque to prevent casing deformation.
2. Gap Setting: Position the probe to achieve the nominal gap distance as specified in the machine train documentation. Secure the jam nut firmly to prevent shift during operation.
3. Connector Integrity: Use the ClickLoc mechanism for a secure connection. Ensure that no mechanical strain is applied to the cable transition area at the probe base.
4. Shielding: Maintain electrical continuity of the coaxial shield to the instrument ground. Avoid grounding the shield at the probe end to prevent ground loops that could introduce signal noise.